![]() ![]() I've spent the last couple weeks trying to figure out how to get sensor values over a serial port, and Roy hit all the same roadblocks that I'm running into. Hello, sorry to dig up this post but it looks everything said here applies to my problem. But if you say 115000 bps is available, then even long strings shouldn't make things too slow. ![]() ![]() The user should be able to pick the sensor values he would like to have sent to the COM port, including the labels and measurement units. Well, no, we wouldn't go for such a constrained (non-flexible) solution. That makes 36 characters in the constelation, that is 360 bits.īut that's not all that much, since such ads are rather crude and sluggish.Īpart from that, even the small Arduino Uno creates the 115000 baud. So only the most necessary joined together with separators. I do not see this as such a big problem, because if you can put together the data you need, similar to the LCD's and only relavantes further, the string should not be too long. Unless of course your serial connection is a relatively high performance one, like 115000 bps. Hence I don't think it would be optimal to simply push the raw data (like the full content of the shared memory) as a long string to the COM port. The problem with pushing a long string to the COM port would be the amount of data going through a rather narrow pipe (e.g. Then the selection of the Com Port, a baud rate and interval to it and done. Just like the individual display parts on the LCD's. I think for such an issue would be the modding scene and also the hobbyists who might want to control their heating inversely proportional to the CPU load, grateful.įor the output formatting I would like a variable solution in which you simply put together a string. Without this monster of MS Visual Studio and knowledge in C # or Python you can not get on with it. However, these solutions always consist of small self-written programs, which use either the shared memory of AIDA64 or the OpenHardwareMonitor library or their web interface. But passing on the data to the microcontroller seems to be more difficult.ĭuring my research on the net I found a lot of demands, but only a few solutions. The idea is to build a steampunk case and it always looks good when old analog gauges or segment displays are used.ĭriving the individual parts is no problem with an Arduino. ![]()
0 Comments
Leave a Reply. |